Expert Answers about Camper Jacks
- Powered Camper Jack Recommendation for 8 foot Alaskan Truck Camper
- There isn't a way to convert the manual jacks you have on your camper now to electric so your best option would be to go with the HappiJac electric camper jack system part # LC736514-ELKIT to give you a powered jack system that would work great on your 8 foot Alaskan camper.
view full answer... - 4 Point Manual Camper Jack System Recommendation
- A simple to use, manual truck camper jack setup, I recommend the HappiJac Manual Truck Camper Jack System # LC736515-4.
This kit comes with 4 camper jacks capable of lifting 11,200-lbs, and can lift to a maximum height of 36-1/2".
This kit does also come with the mounting hardware needed for installation.
view full answer... - Recommended Truck Bed Camper Jack for 2011 Ram
- If you are looking for truck bed camper jacks for your 2011 Ram, I recommend looking at the Brophy Cable Camper Jacks # CJ74. These will allow you to easily load or unload your truck camper with just a pair of portable jack assemblies. They have a lifting range of 17 to 67 inches and a combined weight capacity of 3,000 pounds. The overall height when assembled is 76 inches.
I have attached a link that will take you to our available selection of truck camper jacks that you can also look...
view full answer... - Powered Jacks for Truck Bed Campers
- We have exactly what you want. HappiJac has a set of 4 that you can add to your camper. This will allow you to control all 4 of the jacks individually from a remote control. You will choose based on the weight of the camper.
The heavier set is the HappiJac Electric Truck Camper Jack System - 36-1/2" Lift - 11,200 lbs part # LC736515-ELKIT
The lighter set is the HappiJac Electric Truck Camper Jack System - 34-1/2" Lift - 8,800 lbs part # LC736514-ELKIT
These will take a lot of the stress...
view full answer... - Jacks to Lift a Truck Bed Camper Out of a Ford Ranger
- There are actually special jacks for truck bed campers like yours. We carry some manual camper jacks, # CJ41, rated for 3,000 pounds. They have a 57 inch maximum lift height. It is recommended that 2 people operate the jacks simultaneously to make it easier to raise each side of the camper evenly. However, 1 person can do the job by alternately lifting or lowering each jack in small increments.
Landing gear types of jacks such as # UF17-943010 are for 5th wheel trailers and would not have...
view full answer... - Recommendation for Stabilizers on Pop Up Camper
- Typically, pop up camper owners will use scissor jacks like the Ultra-Fab Ultra Scissor Jack, # UF48-979002, to stabilize their camper. This pair of scissor jacks can either be bolted or welded to the frame of your camper and has a 24 inch lift. Each jack has a support capacity of 6,500 pounds.
Ultra-Fab also offers these jacks in a 30 inch lift, # UF48-979031.
view full answer... - Recommended Replacement Jacks for 2005 Lance 1191 Truck Camper
- I am not sure what model Atwood Jacks you currently have on your 2005 Lance 1191 Truck Camper, but I do have a replacement option that should work well.
I recommend looking at the Brophy Cable Camper Jacks # CJ74. These have a combined weight capacity of 3,000 pounds but only require the use of 2 cable jacks. The lifting range on this system is 17 inches to 67 inches and they are operated by a hand winch. The price information will be listed on the product page.
I have also attached...
view full answer... - Recommended Manual Jack System for Fleetwood Truck Bed Camper
- For your 1999 Fleetwood Elkhorn Truck Camper, the electric jacks are notorious for failing and replacement parts are not easy to find. We unfortunately don't have the threaded rod you need to keep your jack from slipping. Manually adjusting it won't change the slipping issue, so you will need to use standard stabilizer jacks and a manual lift.
The Brophy Heavy Duty Cable Camper Jacks - 57" Max Lift Height - 4,000 lbs - Qty 2 # CXHD is the best system we have available and what I recommend...
view full answer... - Using CR Brophy CJ74 Camper Jacks to Lift Heavy Camper Shell
- As long as the camper shell weighs less than the 3,000 lb capacity of the # CJ74 Camper jacks, you should only need one set. The lift bracket itself is 26-1/2 inches long, so be sure to place the brackets at the center of gravity of the camper shell so it'll be balanced once it's up on the jacks. If the camper shell is heavier, using 2 stes would be recommended.
view full answer... - Brophy Cable Camper Jacks For 1972 Cab Over Camper
- The Brophy Cable Camper Jacks - QTY 2 # CJ74 should work fine for your 1972 cab over camper. As long as the combined weight does not exceed 3,000 lbs. The uppermost poles on these jacks are elongated so you can lift your camper up to 67" off the ground, which should be more than enough to clear the bed rails of even the loftiest truck on the road.
view full answer... - Will Replacement Flat Bracket for HappiJac Truck Camper Jacks Work with Manual to Electric Jack Kit
- Yes, the mounting bracket part # LC182494 does have the same bolt pattern as the jacks that your Manual-to-Electric Conversion Kit for HappiJac Truck Camper Jack Systems Item # LC733960-182524 would attach to.
view full answer... - A-Frame Trailer Jack Recommendation for Camper
- We have several jacks here that should work well on your camper. The etrailer A-Frame jack part # TJA-5000S-B that you referenced would be a great choice for if you are looking for an A-frame style jack with a higher capacity.
view full answer... - Are There Rebuild Kits for HappiJac Electric Truck Camper Jacks Model 4100 and 4500
- I do have an option for you but we don't have rebuild kits for the HappiJac Electric Truck Camper Jacks Model 4100 and 4500. These jacks have been discontinued and I recommend a full replacement system, the HappiJac Electric Truck Camper Jack System part # LC736514-ELKIT which is designed to replace both of these models. This is a complete system that comes with new jacks, motors, wringing, control box, and remote.
view full answer... - How to Order a Quantity of 4 Camper Jacks
- The best priced pair of camper jacks we offer is the part # CJ31. If you needed a total of 4 of these jacks you'd need to order a quantity of 2 of these.
view full answer... - Recommended Stabilizer Jacks for 13-foot Camper Trailer
- A camper that weighs about 2500-lbs can use stabilizer jacks rated for less than this total weight load since they will not have to bear that total when simply steadying the camper.
For a cost-effective scissor jack I suggest the etrailer # TJSC-24 which offers bolt-on installation. This is sold as a single jack so order two.
All similar stabilizer jack options are shown on the linked page.
view full answer... - Replacement Jack Leg for HappiJac Truck Camper Jack System Model 4150
- Yes, the Replacement Jack for HappiJac Truck Camper Jack System part # LC736514 (Model 4220) will fit your HappiJac Truck Camper Jack System Model 4150. If you need a new gearbox/motor then we have that as well, the Replacement Motor and Gear Head Assembly part # LC182515. I called Lippert to confirm all of this info for you.
view full answer... - Solution for Titan Camper Jack System Replacement for Setup with Motors
- I may have a solution you'd be interested in for you to upgrade to electric jacks, but your Titan jacks are not compatible with a HappiJac # LC733960. Instead, your best bet is going to be getting a new HappiJac system like the HappiJac Electric Truck Camper Jack System - 36-1/2" Lift - 11,200 lbs # LC736515-ELKIT.
view full answer... - Homemade Slide In Camper Lift Recommendations
- For your horizontal clearance this will really come down to your specific truck as well. The Brophy Cable Camper Jacks have an offset lifting point that is designed to even with the legs of the jacks themselves. So if your truck has fenders that may bulge as it approaches the wheel wells, or your tires are wider than the outer fenders this would cause them to contact the stand and would not work. I personally would want to see at least 4" from the widest point to ensure enough clearance....
view full answer... - Truck Camper Shell Jack Recommendation for 1997 Dodge Ram 2500
- The camper jacks by Brophy part # CXHD have a 4,000 lb capacity and would be a great option for your heavy camper.
With this heavier duty set you'd only need one set instead of two.
view full answer... - Will Square A-Frame Jack w/ Footplate # TJDA-5000S Fit 2014 Starcraft 16rb Launch
- Yes, the Square A-Frame Jack w/ Footplate # TJDA-5000S that you referenced is a fit for the a-frame of your 2014 Starcraft 16rb Launch Camper.
view full answer...
Go To Results